![]() ![]() Enable the new plugin by clicking on the red cross on the left column next to the plug in. Start mach3 and click on Menu -> config ->Config Plugins. ![]() Next, you will need to configure mach3 to use the plugin library. 2nd I noticed that the USB to serial IC is unlabeled and it is not because the name has been scratched off as is sometimes done to hide a critical IC's identity. This method is recommended since serial ports are not as common in computers these days. It also gives a clue as to the quality of the build. Not a problem as far as the operation of the adapter goes but mechanically it will cause premature failure of the device as it puts strain on the USB connectors pins. ![]() ![]() 1st the metal case of the USB plug was not soldered to the circuit board. When i got the new one I opened up both RS485 adapters and I noticed 2 things about the first adapter I have purchased. It assumes an already working spindle PD001 2 Enable RS485 PD002 2 Enable RS485 PD004 400 Spindle frequency from spindle name plate PD023 1 Disable reverse rotation of spindle PD163 1 VFD Address PD164 1 Baudrate 9600 PD165 3 8bit, No parity, 1 Stopbit, RTU RS485 adapters I had a bit of trouble with the first adapter I purchased with it failing to change the speed of the VFD intermittently and seemed to run slow on startup with the UCCNC plugin. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |